Wiring
Wiring should only be performed by qualified
personnel only. All wiring must comply with all
applicable codes and standards. The voltage of the
power source must match the voltage indicated on the
Air Cleaner. The Air Cleaner should operate ONLY
when the system fan is running. Make sure the Air
Cleaner is properly grounded.
Wire the Air Cleaner directly to the 120 V power
source. The APS will power the Air Cleaner when there
is sufficient airflow to activate the sensor. See Fig 5 &
6.
Note: The power switch will be lit even if there is no
airflow.
Fig. 5
Models ASAS-10ASC/GSAS-10ASC, ASAS-11ASC/GSAS-11ASC
(with Air Proving Switch)
Fig. 6
Models ASAS-12ASC/GSAS-12ASC, ASAS-18ASC/GSAS-18ASC
(with Air Proving Switch)
SYSTEM CHECK
Perform the following system check before operation.
1. Replace prefilters, collecting cells and carbon
filters. Close access door.
2. Turn Air Cleaner power switch ON. Ensure system
fan is operating. Both the power switch light and
performance indicator light should be lit. The power
switch light indicates the Air Cleaner has unit
voltage. The performance indicator light shows that
the Air Cleaner is operating.
Note: There may be some arcing or snapping sounds
from the collecting cells. This is normal when the unit is
new. In about 2 weeks, as the sharp edges of the cells
become smoother, the arcing will disappear.
OPERATION
The Air Cleaner will run as long as there is airflow
through the ducts. The Air Cleaner will not run if the
system fan is off. For proper operation, follow these
simple steps:
1. Run heating/cooling system fan continuously, and
on low speed if available.
2. Remove furniture or carpets which block return air
grilles throughout your house, so that air moves
freely to the furnace/ air conditioner.
3. Check for proper operation of the system fan.
WHITE DUST
After installation of the Air Cleaner, you may notice
some white dust on tabletops and shelves. Most large
particles such as lint, are too heavy to remain airborne
and tend to settle quickly, never reaching the air
cleaner.
This white visible dust is normally referred to as
“clean dust.” As the Air Cleaner is removing the dark
and staining particles from the air, the lint will also be
cleaner.
Lint dust is most noticeable on dark furnishings; in
homes containing new carpeting; and where there is a
lot of household traffic from occupants and pets. To
reduce lint dust, use continuous fan operation and keep
return vents unrestricted to create an efficient airflow.
Note: The Air Cleaner does NOT produce more lint or
dust.
MAINTENANCE
It is important to follow a scheduled maintenance for
maximum performance of the Air Cleaner.
Cell And Prefilter Cleaning
The collecting cells and prefilters must be cleaned on a
regular basis for the Air Cleaner to function at its peak
WARNING
Electrical shock can cause injury or death. Be certain
main line disconnect switch is off before wiring.
CAUTION
Make sure to turn Air Cleaner and system fan OFF
before performing any maintenance or removing any
components.
(16 strony)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji